How To Fix Garage Door Sensor Alignment. The first thing that we will do when we reach your house is to reassess the situation of your. Loosen the screws that mount each of your garage door sensors.
If it shows red, it is faulty. Pull the string taut and tie to the other bracket in the same position. Remove existing wires from the white and grey terminals on the back of the.
After All Is Connected, You Can Plug The Garage Door.
Remove the wires from the wire nuts or cut the sensor wires 12″ from the sensors. You will need to loosen them so that you can move the track. Please leave this field empty.
If Not, Try To Make Some Adjustments On One Or Both Garage Door Sensors.
Locate some string, and tie it to one of the mounting brackets. If it shows red, it is faulty. Do the same on the other side.
Check The Exterior Flashing Led Lights When You Open The Garage Door.
Using a level, check that the string is level. Or, fill out the form and we will contact you as soon as possible. The bolts on the mounting bracket hold the track in place.
Aligning Garage Door Sensors Reassess The Situation.
Be sure not to remove them completely, as you will need them later. If not, adjust the sensor until it is level with the other one, and then secure it back into position. Pull the string taut and tie to the other bracket in the same position.
Lay A Spirit Level Over This, And Check If It’s Level.
Loosen the screws that mount each of your garage door sensors. Press the level manually against the string and keep it in place for a few seconds. Pull that string across to the other mounting bracket, and tie it to it.